Installation Instructions; Boom Rail Assembly - Schartec Move 600 Installation And Operating Instructions Manual

Check out our assembly video by scanning this QR code with your smartphone!

Boom Rail Assembly

2 Part Boom Rail
A:1500 mm
3 Part Boom Rail
C:1000 mm
1. 2-Part Rail
First, align the 3 parts in a row on the floor like in Figure 2. Remove the trolley piece with the straight
arm piece. Slide the belt wheel with the screw rod along with the belt through all 3 parts, but not
completely to the end. Before putting part A and B into the sleeve, place the trolley with the straight
arm piece into the rails with the straight arm piece being placed in first into part B. Now slide part A
and B into the sleeve until the notch fits into the groove on both parts. Pull the belt wheel with the
screw rod to the end of the rail.
3-Part Rail
The assembly is the same as the 2-Part Rail with the addition of the 2nd sleeve part.

Installation Instructions

or visit www.schartec.de/en/
Sleeve
D:1000 mm
Sleeve
35
B:1500 mm
E:1000 mm
Sleeve
Figure 2
Figure 3