Table of Contents
Advertisement
8. Remove only the tagged shipping bolt that is attached to the load cell. This bolt supports the
weighbridge during transport and installation.
Note
DO NOT loosen or tighten the overload bolt—it has been factory set to minimize the
possibility of load cell damage resulting from incidental overload.
9. Remove the locking pin on the belt plow and scraper to allow them to contact the belt
properly. On units with an optional gravity tensioner and tracker the locking pin will also need
to be removed.
Note
Store these pins as they can be used to support the parts during a belt change.
10. Before starting the weighfeeder, make a final check to see that the conveyor belt is free of all
tools and foreign objects, and that the infeed/skirtboards are not pinching against the belt.
SITRANS WW300
Operating Instructions, 05/2015, A5E33560691-AB
Installing
4.1 Installation steps
13
Advertisement
Table of Contents
