CDA akd01 Manual For Installation, Use And Maintenance page 11

• Insert the disposer body (8) into the
flange (2) by pushing upward.
• Use the clamp (6) to lock this in place
(Fig. 3).
• Thread the outlet flange (10) onto the
drain tube (12).
• Fit the rubber seal (9) onto the lip of
the drain tube (12) and tighten this
assembly onto the disposer body (8)
(Fig. 4).
Waste trap installation
recommendations
• To improve the flow of water, all pipes
should be cut to length and internally
deburred.
• The waste disposer is supplied with
inlet "A" blanked off (Fig. 5). This
inlet may be used to connect a sink
overflow using a flexible hose. If
using this it is necessary to remove
the plastic plug as shown in Fig. 6
before fitting the disposer.
Fig. 4
Fig. 5
Fig. 6
11