CDA akd01 Manual For Installation, Use And Maintenance page 10

Installing the waste disposer
We recommend that before you start
installation you check the existing drain
pipe is in good condition and that any
obstructions are removed.
Part reference numbers below refer
to the diagram on page 9
• If fitting to an existing sink installation
it is necessary to remove the sink
drain and waste trap previously
installed.
• Clean the sink flange area of any
putty or other debris.
• Open the clamp (6) and remove the
sink flange (2). (Fig. 1).
• Unscrew the mounting ring (5) and
remove the fibre washer (4).
• Pass the sink flange (2) through the
rubber washer (3) and the sink hole.
• Tighten the mounting ring (5) with
fibre washer (4) onto the sink flange,
then tighten the screws so the sink
flange is seated firmly.
• Check that the splash guard (7) is
fitted to the disposer body (8).
• Wet the splash guard (7) with water.
10
Fig. 2
Fig. 3