Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Summary of Contents for CDA akd01
- Page 1 & akd02 Waste Disposers Manual for Installation, Use and Maintenance Customer Care Department • The Group Ltd. • Harby Road • Langar • Nottinghamshire • NG13 9HY T : 01949 862 012 F : 01949 862 003 E : customer.care@cda.eu W : www.cda.eu...
-
Page 2: Appliance Information
Appliance information: Please enter the details on the appliance rating plate below for reference, to assist CDA Customer Care in the event of a fault with your appliance and to register your appliance for guarantee purposes. Appliance Model... - Page 3 CE Declarations of Conformity: This appliance has been designed, constructed and marketed in compliance with safety requirements of EEC Directive 2006/95/EEC (Low voltage) and requirements of EMC Directive 2004/108/EEC. This appliance has been manufactured to the strictest standards and complies with all applicable legislation, including Electrical safety (LVD) and Electromagnetic interference compatibility (EMC).
- Page 4 Important • This appliance is designed for disposal of domestic foodstuffs only. Any other use falls outside the design criteria so will be considered dangerous and will invalidate the guarantee. • The appliance must be installed under a sink in a purpose-designed kitchen unit.
- Page 5 Abrasive cleaners such as scouring products and grits (including creams such as Cif) • CDA and its agents cannot be held responsible for any damage or injury caused by improper use of this appliance. • This appliance should not be installed in locations where the ambient temperature may fall below 0°C.
- Page 6 Using Your Waste Disposer To dispose of domestic food waste • Ensure that your hands are dry, then turn on the electrical supply to the waste disposer. • Turn on the cold tap to run water through the disposer. • Start the disposer, by a firm press of the air switch button. •...
-
Page 7: Care And Maintenance
Care and Maintenance Routine cleaning In normal use, as described above, the waste disposer is unlikely to require cleaning or maintenance. If an unpleasant smell develops, due to buildup of greasy particles, or if you intend not to use the waste disposer for a lengthy time, we suggest the following procedure: •... -
Page 8: Troubleshooting
• Run water through the waste disposer and start it up normally. Troubleshooting If you have any problems with your appliance you should check this troubleshooting table prior to calling CDA Customer Care, to prevent unnecessary service calls and potential cost. You observe that... -
Page 9: Installation
Installation Identification of parts Identify and check all necessary parts, as Fig. 2. 1 Plug / Pusher 2 Sink flange 3 Rubber washer 4 Fibre washer 5 Mounting ring 6 Clamp 7 Splash guard 8 Disposer body 9 Rubber seal 10 Outlet flange 11 Screws 12 Drain tube... - Page 10 Installing the waste disposer We recommend that before you start installation you check the existing drain pipe is in good condition and that any obstructions are removed. Part reference numbers below refer to the diagram on page 9 • If fitting to an existing sink installation it is necessary to remove the sink drain and waste trap previously installed.
- Page 11 • Insert the disposer body (8) into the flange (2) by pushing upward. • Use the clamp (6) to lock this in place (Fig. 3). • Thread the outlet flange (10) onto the drain tube (12). • Fit the rubber seal (9) onto the lip of the drain tube (12) and tighten this Fig.
-
Page 12: Air Switch Installation
Air switch installation Identify and check all necessary parts, as Fig. 7. A Air switch B PVC air tube (1m supplied) C Push button bellows D Mounting bracket Fig. 7 • The air switch needs to be fitted into a 35mm diameter hole within easy reach of the user. -
Page 13: Electrical Information
located in the base of the waste disposer body. • The mounting bracket (D) is supplied as an alternative mounting for if you choose to mount the air switch button under the sink out of sight. Electrical Information Warning! This appliance must be earthed. The mains lead of this appliance has been fitted with a BS 1363A 3 Amp fused plug. - Page 14 If in doubt regarding the electrical connection of this appliance, consult a qualified electrician. N.B. Ensure that the plug socket is situated in an easily accessible place. If the power supply cord is damaged, it must replaced by a CDA authorised agent. Mains electrical voltage: 230Vac, 50 Hz...
- Page 15 Your waste disposer is guaranteed against defects in materials and/or workmanship for 12 months At the discretion of CDA, should a fault arise, the waste disposer may be repaired or replaced and agreed refitting may be reimbursed on receipt of a faulty part, once they have been inspected and deemed...
- Page 16 Please contact our Customer Care Department for Service on the details below Customer Care Department • The Group Ltd. • Harby Road • Langar • Nottinghamshire • NG13 9HY T : 01949 862 012 F : 01949 862 003 E : service@cda.eu W : www.cda.eu...