Table of Contents
Advertisement
GENERAL SAFETY INFORMATION
Safety instructions for installation and operating personnel
The operating instructions provided here contain essential safety instructions for installation personnel
and those engaged in the operation, maintenance and servicing of the equipment.
Before commencing installation or commissioning:
•
Read and understand the contents of this manual
•
Ensure installation and operating personnel have received adequate training for this task
•
Ensure that any operating instructions are fully understood by the personnel responsible.
•
Observe national and local installation and mounting regulations (e.g. IEC 60079-14).
During operation:
•
Make the relevant instructions available at all times to the operating personnel.
•
Observe safety instructions.
•
Observe national safety and accident prevention regulations.
•
Operate the equipment within its published specification.
•
Servicing, maintenance work or repairs not described in this manual must not be performed without
prior agreement with the manufacturer.
•
Any damage to this equipment may render its explosion protection null and void.
•
No changes to any of the components that might impair their explosion protection are permitted.
If any information provided here is not clear:
•
Contact Eaton's MTL product line or one of its representatives.
Note: Improper installation and operation of the enclosure can result in the invalidation of the guarantee.
Earlier models of the Fieldbus Barrier Module (9377-FB) that do not have the "-R" at the
end of the model number cannot be used in the produbts described here.
A mechanical interlock prevents their being fitted to the carriers. Do not attempt to fit
these models as damage to the carrier may result.
2
Failure to comply with these instructions can endanger the lives or health of
personnel and risk damage to the plant and the environment.
The responsibility for planning, installation, commissioning, operation and
maintenance, particularly with respect to applications in explosion-hazard areas,
lies with the plant operator.
These assemblies may not be used in explosion-hazard area applications if they
have been used previously in general electrical installations.
WARNING!
WARNING!
WARNING!
CAUTION
INM 9370-RD Rev 5
Advertisement
Table of Contents
