Sony SU-FL61 Instructions Manual page 6

Assemble the TV Stand
WARNING
If you allow the mains lead to be pinched under or between
pieces of equipment, this may result in a short circuit or an
electric shock. If you stumble over the mains lead or the
connecting cable, the TV Stand may topple over and cause
injury.
Decide on the installation location and lay the TV
Stand down before installing the TV.
Since the TV is heavy, it is recommended that you decide
on the installation location and lay the TV Stand down
before installing the TV.
1
Detach the front and rear pillar
support panels from the centre
pillar.
Rear pillar
support panel
6
(GB)
2
Front pillar
3
support panel
Attach the centre pillar to the
frame.
Secure the centre pillar to the frame with the four
screws.
Notes
• Be sure that two or more persons assemble the TV Stand.
• Loosely attach the centre pillar to the frame with the four
screws, then tighten all screws sufficiently.
• When using an electric screwdriver, set the torque setting
to approximately 1.5 N·m {15 Kgf·cm}.
As shown below, attach the front
pillar support panel.
Note
Before attaching the front pillar support panel, check that the
four screws are firmly tightened.
Frame
Screw