Installation Tools; Product Installation - TP-Link TL-SG1008PE Installation Manual

Extremely high voltage currents can be produced instantly when lightning occurs and the air in the
electric discharge path can be instantly heated up to 20,000
enough to damage electronic devices, more effective lightning protection measures should be
taken.
Ensure that the rack and the device are well earthed.
■
Make sure the power socket has a good contact with the ground.
■
Keep a reasonable cabling system and avoid induced lightning.
■
Use the signal SPD (Surge Protective Device) when wiring outdoor.
■
Note:
For detailed lightning protection measures, refer to the Lightning Protection Guide from the
Related Documents of our website:
https://www.tp-link.com/en/configuration-guides/lightning_protection_guide/?configurationId=2962
Installation Site
When installing the device on a rack or a flat workbench, attach much importance to the following
items:
The rack or workbench is flat, stable, and sturdy enough to support the weight of 5.5 kg at least.
■
The rack or workbench has a good ventilation system. The equipment room is well ventilated.
■
The rack is well grounded. Keep the device less than 1.5 meters away from the power socket.
■
2.3

Installation Tools

Phillips screwdriver
■
ESD-preventive wrist wrap
■
Cables
■
Note:
These tools are not included with our product. If needed, you can purchase them separately.
2.4

Product Installation

Desktop Installation
■
To install the device on the desktop, follow the steps:
1. Set the device on a flat surface which is strong enough to support the entire weight of the device
with all fittings.
2. Remove the adhesive backing papers from the rubber feet.
3. Turnover the device and attach the supplied rubber feet to the recessed areas on the bottom at
each corner of the device.
Unmanaged/Easy Smart Rackmountable Switch
°C . As this instant current is strong
Installation 11