First Aid; In The Event Of A Problem - TEFAL Aqua Perfect HD522 Series Instruction Manual

EN
CLEANER AND DESCALER PROVIDED WITH THE APPLIANCE
INSTRUCTIONS FOR USE:
1- Turn off the unit and remove the water tank.
2- Add the powder from 2 bags to 0.6 liters of hot water in a container.
Stir until the powder has completely dissolved.
3- Fill the water base with this solution and wait for 1 hour to take effect.
4- Empty and remove the scale using the brush provided with the product.
5- Rinse out the whole of the compartment with fresh tap water.
(Important, make sure that no water gets into the fan air outlet).
6- Your appliance is now ready to be used again.
WARNING: keep out of reach of children - harmful if ingested - Irritating to eyes and skin.

FIRST AID:

EYE CONTACT: flush immediately with water for at least 15 minutes and seek medical advice.
SKIN CONTACT: wash immediately with soap and water.
INGESTION: drink enough water to spit ; may cause upset stomach -Get medical advice/attention.
INGREDIENTS:
Citric Acid >99%
You can also use the ANTICALC KIT of KRUPS, sold as accessory, F054 (F054001).
Please notice, only 20 grams of the powder are necessary for the descaling operation of your device.
STORAGE
When the appliance is not in use, it should be stored in a dry place.
Make sure to empty the tank, clean and dry the appliance before storing it.

IN THE EVENT OF A PROBLEM

Never dismantle your appliance yourself. An incorrectly repaired appliance can be a danger to the user.
Before contacting an approved Service Centre from our network, make sure that the appliance is in the
normal operating position and the air intake and outlet grills are totally unobstructed.
P roblem
The appliance does
not work when swit-
ched on
Possible Cause
The target humidity is reached.
The water level indicator is
blinking.
The water tank isn't well posi-
tioned.
The appliance isn't on a flat
surface.
The water level required has
not yet reached the vaporiza-
tion compartment.
The RH% of the room is over
90%.
Increase the target humidity in CONTROL
MODE or select CONTINUOUS MODE.
Refill the water tank.
Check the positioning of the tank on the
base.
Check the positioning of the appliance (tilt).
Wait at least 20 secs.
Wait till the RH% of the room gets below
80%.
12
What to do