Operating instructions
Note:
•
The motor runs the risk of overheating if it is run for too long continuously:
-
Run it for max 15 seconds under no load
-
Run it for max 60 seconds under load
•
Make sure that the hand blender is clean before use.
•
Never blend hot oil or fat.
•
Never add ingredients while the blender is switched on.
Switching on/off
Start the hand blender by pressing in the power trigger.
Release the power switch to switch the hand blender off.
Care and maintenance
•
Unplug the mains lead from the wall socket before cleaning. The blade is extremely
sharp and could cause serious personal injury if the blender were to start accidentally.
Note: The motor unit and power switch must never be exposed to water.
•
The exterior of the motor unit can be cleaned by wiping it with a damp cloth. Use
only mild cleaning agents, never solvents or corrosive chemicals. Never immerse
the motor unit in water.
•
The mixing stem can be washed by lowering it into warm soapy water and running
it for a few seconds to clean the blades. The mixing stem and blade should then
be rinsed with warm water.
•
If the mixing stem is rinsed
under running water care
must be taken not to get any
water on the motor unit and
power switch.
5