7. Usage and Settings
■ 7.1 How to Switch to Each Mode
7.1.1 Modes and Functions
コンパレータ設定
Comparator Setting
ループチェックモード
Loop Check Mode
・ヒステリシスの設定
• Hysteresis setting:
設定点、接断差の設定
Set the dead band/ set point
on,offディレー時間の設定
Set the ON/OFF delay time
・ウインドコンパレータの設定
• Window comparator setting:
Set the output setting range
出力設定範囲の設定
Set the ON/OFF delay time
on,offディレー時間の設定
3 sec. or longer
電源
測定モード
Power
Measurement Mode
投入
ON
・圧力表示
• Pressure display
・コンパレータ出力
• Comparator output
・アナログ出力
• Analog output
or
Peak
Bottom
(When holding down)
ピークホールド表示モード
Peak Hold Display Mode
・ピークホールド表示
• Peak hold display
印加された圧力最大値の表示
to display max. applied pressure
・ボトムホールド表示
• Bottom hold display
to display min. applied pressure
印加された圧力最小値の表示
●
3 sec. or longer
Less than 3 sec.
Less than 3 sec.
3 sec. or longer
"- - - -" is displayed when MODE or ADJ. key is pressed. "SET
LED" flashes when ADJ. key is held down for 3 seconds or
longer to show that a long press was established.
Function Setting Mode
・コンパレータ動作の選択
• Select the comparator operation
・表示の選択
• Select the display
・LED表示のスケーリング設定
• Set the LED display scaling
・アナログ出力のスケーリングの設定
• Set the analog output scaling
• Select the filter
・フィルタの選択
3 sec. or longer
3 sec. or longer
終了
End
・印加された圧力と無関係に手動で
• Manual testing of the pressure
display, comparator output and
圧力表示、コンパレータ出力、
analog output regardless of the
アナログ出力をテスト
applied pressure
<Fig.7-1>
13
機能設定モード
ゼロ調整モード
Zero Adjustment Mode
・表示値、アナログ出力の
• Zero-point adjustment of
the display value and
ゼロ点調整
analog output
ループチェックモード
Loop Check Mode
TY-GC62-010A Rev.2