Pentair INTELLICENTER Installation Manual page 2

2
Access the Outdoor Control Panel in the Load Center or Power Center
BEFORE INSTALLING AN EXPANSION OR PERSONALITY CARD ALWAYS SWITCH
OFF AC POWER TO THE LOAD AND/OR POWER CENTER AT THE MAIN HOUSE
CIRCUIT BREAKERS.
®
The IntelliCenter Control System Main Motherboard Outdoor Control Panel is located in the top part of
the Load Center or Power Center enclosure.
To access the Main Control Panel Motherboard:
1. Unlatch the front door spring latch and open the front door of the Load Center enclosure.
2. Loosen the two (2) retaining screws securing the high voltage cover-panel. Remove the HIGH
VOLTAGE COVER PANEL from the enclosure (as shown below).
Loosen Outdoor Control Panel
retaining screws
Front door
IntelliCenter™ Load Center Control System Load Center (front view)
3. Install an Expansion and/or Personality Card onto the Main Motherboard (See page 3):
4. Carefully align the card edge connector (component side facing up) with the card edge pins on the
other card. Slide the Expansion card onto the Motherboard's edge connector.
5. Secure the card in place with the two retaining screws (provided in kit).
IntelliCenter Control System Expansion Card Installation Guide
High Voltage Cover Panel slots (3)
(High Voltage Cover Panel removed)
Flip down the Outdoor Control Panel
to access the Main Motherboard circuit
board
Remove two (2) retaining screws
securing High Voltage Cover Panel
High Voltage Cover Panel Tabs (3)