Either the analog control mode or serial communication control mode can be used with this lens.
The control mode is selected using the control mode selection switch.
Note: Before attempting to change the switch settings, turn off the power of the lens and control signal input.
Setting
Referring to the illustration below, set the control mode selection switch.
For the detailed settings used in each control mode, refer to the analog control mode settings (page 10) or serial
communication control mode settings (page 11).
Note: The analog control mode is set as the factory setting.
Analog control mode
ANALOG
SERIAL
Serial control mode
SELECTION OF CONTROL MODE
Switch Settings
Switch
Switch
9
- -