Initial Mds Entranet Programming And Setup; Redundancy Menu - GE MDS P21 Installation & Operation Manual

30 P21/P22/P23 Protected Network Station
RSPSupply - 1-888-532-2706 - www.RSPSupply.com
http://www.RSPSupply.com/p-8464-MDS-P22-Redundant-Transceiver-Chasis-(Enet).aspx
3. Configure Radio A (upper unit) as appropriate. Save the configura-
tion file to a TFTP server as described in the transceiver manual.
4. Set the front panel
RADIO SELECTION
saved configuration file into Radio B (lower unit).
5. This completes the configuration procedure. Set the front panel
switch to , re-install the top cover, and the unit is ready for ser-
AUTO
vice.

4.2 Initial MDS entraNET Programming and Setup

This section presents menu settings for MDS entraNET transceivers
used in P22 Protected Network Stations. Only menus pertaining directly
to protected network operation are covered here. Please refer to the
transceiver manual (Part No. 05-4055A01) for a complete list of radio
commands and other operation details.
(For instructions on programming MDS iNET/iNET-II Series trans-
ceivers, see "Initial MDS iNET/iNET-II Programming and Setup" on
Page 23.)
NOTE: MDS entraNET radios used in a Protected Network Station
must have firmware revision 2.3.7 or higher installed. Consult
the factory for firmware availability.

Redundancy Menu

Redundancy is available only at the AP. The Redundancy Menu is used
in protected installations where a backup transceiver can be immedi-
ately placed online should a primary unit fail. This protects against
"single point of failure" scenarios. The Redundancy menu contains
selections and settings that are used to manage redundancy functions.
NOTE: The chassis uses a Switchover Logic Board (Part No.
03-6061Axx). This board is similar in appearance to the one
used in P20 configurations, but they are not interchangeable.
Consult factory for assistance with replacement PCBs.
switch to " ". Download the
B
05-4161A01, Rev. C