Programming The Transceivers; Initial Mds Inet/Inet-Ii Programming And Setup; Redundancy Configuration Menus - GE MDS P21 Installation & Operation Manual

Protected network stations, equipped with mds inet series, entranet, or mercury transceivers
Table of Contents

Advertisement

23
P21/P22/P23 Protected Network Station
RSPSupply - 1-888-532-2706 - www.RSPSupply.com
http://www.RSPSupply.com/p-8464-MDS-P22-Redundant-Transceiver-Chasis-(Enet).aspx
4.0 PROGRAMMING THE
TRANSCEIVERS
This section presents menu settings for transceivers used in Protected
Network Stations. Only menus pertaining directly to protected network
operation are covered here. Please refer to the transceiver manual for all
other radio commands.
• For instructions on programming MDS iNET/iNET-II Series
transceivers, see "Initial MDS iNET/iNET-II Programming and
Setup" below.
• For instructions on programming MDS entraNET transceivers,
see "Initial MDS entraNET Programming and Setup" on Page
30.
• For instructions on programming MDS Mercury transceivers,
see "Initial MDS Mercury Programming and Setup" on
page 35.
4.1 Initial MDS iNET/iNET-II Programming and
Setup
This section presents menu settings for MDS iNET/iNET-II Series
transceivers used in P21 Protected Network Stations. Only menus per-
taining directly to protected network operation are covered here. Please
refer to the transceiver manual for a complete list of radio commands.
NOTE: Radios used in a Protected Network Station chassis must have
firmware installed that supports redundant configuration.
MDS iNET/iNET-II Series transceivers must have revision
5.1.0 or higher installed. Consult the factory for firmware
availability.
NOTE: To ensure proper operation after a switchover, both trans-
ceivers in a Protected Network Station must have identical
configurations. After setting the configuration of one trans-
ceiver, refer to "Mirrored Configuration" of Transceivers on
Page 29 to transfer the same profile to the other radio.
Redundancy Configuration Menus
You enter the Redundancy Configuration menus by selecting this option
from the transceiver's Main Menu (Figure 20). If the redundancy func-
tion is not already enabled, a password prompt appears. If you do not
have a password, contact your factory representative for assistance.
05-4161A01, Rev. C

Advertisement

Table of Contents
loading

This manual is also suitable for:

Mds p22Mds p23

Table of Contents