Tire Pressure - Craftsman CMXGRAM1130049 Instruction Manual

Installing the Bumper (If equipped)
1. Remove the two screws (a) as shown in Figure 10.
2. Position the bumper (b) over the mounting holes and secure using the
screws (a) removed in Step 1. See Figure 10.

Tire Pressure

Equal tire pressure should be maintained at all times. Never exceed the
maximum inflation pressure shown on the sidewall of the tire.
The recommended operating tire pressure is:
• 10 psi for the rear tires
• 14 psi for the front tires
Important: Refer to the tire sidewall for exact rating of the tire or maximum psi. Do
not overinflate. Uneven tire pressure could cause the cutting deck to mow unevenly.
Charging the Batteries
California Proposition 65
This product contains a chemical known to the State of California to cause
cancer and reproductive harm.
The batteries contain corrosive fluid and toxic material — HANDLE WITH CARE.
Keep away from children. Do not puncture, disassemble, mutilate, or incinerate.
Explosive gases could be vented during charging or discharging. Charge in a
well ventilated area, away from sources of ignition.
Recharge only with the charger provided with this tractor. A charger that is
not suitable for this machine may damage the batteries or create the risk of
fire.
Do not charge or operate the tractor in the rain or in wet conditions.
(b)
(a)
(a)
Figure 10
WARNING
WARNING
Wash hands after handling.
WARNING
WARNING
WARNING
ASSEMBLY
Rechargeable batteries degrade with time and use. The batteries may eventually
need to be replaced. To have the batteries replaced, contact your authorized service
dealer.
1. Lift the charge port door (a), located on the rear body panel of the tractor.
See Figure 11.
2. Insert the charging cord (b) into the charge port (c). Plug charger cord (b)
into wall outlet. See Figure 11.
Note: It will take approximately 4 hours to fully charge the batteries.
Note: The Vehicle Control Module (VCM) LED's will blink continuously when
charging and the LCD display will display percentage of charge. The battery
is completely charged when all green lights are illuminated and the LCD
displays 100%. Refer to the Operator's Manual for more charging tips.
Note: When the charging cord is plugged into the tractor and not yet plugged
into the wall, the LED's will illuminate continuously until the cord is plugged
into the wall.
3. If at any time you get a charger fault when charging your battery, follow
these procedures:
a. Turn the power key off.
b. Unplug the charger from the tractor.
c. Unplug the charger from the power source.
d. Plug the charger back into the power source.
e. Plug the charger back into the tractor.
f. It the problem persists contact qualified service personnel.
Battery Charging Tips
• Use only the battery charger provided with this tractor.
• The batteries should be fully charged before the initial use.
• Never charge a frozen battery.
• It is recommended that the tractor be charged once every month during
off-season storage.
• Always disconnect battery charger (or extension cord, if used) from the
electrical outlet first, then disconnect battery charger from the charging
port.
• It is recommended that the batteries be fully charged after each use. Storing
batteries in a discharged state could reduce future performance.
• It will take approximately 4 hours to fully charge the batteries. Leaving the
batteries connected to the charger for more than 4 hours will not damage
the batteries.
• The batteries do not develop a memory and do not need to be fully
discharged before recharging.
12
(a)
(c)
(b)
Figure 11