Final Assembly; Adjustment Instructions; Tilt Adjustment; Height Adjustment - Bionaire BSF16 Instruction Leaflet

Step 9. Place the grill ring around the edges of both grills making sure to
enclose both edges with the ring. Then re-attach the Bionaire ® decorative
cap, by passing the screw through the hole on the side of the cap and
using your screwdriver tighten the grill ring together until the fan head
assembly is completely secure.

FINAL ASSEMBLY

Step 1. Insert the extension pole into the lower pole. Insert the two
brackets (Parts R and S) into the top of the lower pole. Make sure to align
the two rectangular plastic tabs with groove inside the pole. Slide the
brackets down until the pole cover is completely inserted into the lower
pole.
Step 2. Once inserted, tighten the screw on the top bracket until it is
secure. Then tighten the height adjustment knob to your desired height
(see below instructions for height adjustment).
Step 3. Pass the power cord though the power cord clip to
secure it into place.

OPERATING INSTRUCTIONS

Step 1. Set the fan base on a dry, level surface.
Step 2. Please make sure the Speed Control Knob is in the "Off" position.
Plug the cord into any standard 120V AC outlet.
Step 3. The SPEED is adjusted by moving the knob left or right to the
desired speed setting. The speeds are indicated by the numbers 1 for Low,
2 for Medium, and 3 for High.
Step 4. The OSCILLATION Knob is located on the bottom of the fan motor
housing. To start oscillation, pull knob down. To stop oscillation, push knob
up.

ADJUSTMENT INSTRUCTIONS

TILT ADJUSTMENT

Step 1. To change the tilting angle of the fan head, move the fan head to
the desired angle.

HEIGHT ADJUSTMENT

Step 1. Turn the height adjustment knob counter-clockwise and slide the
fan up or down to the desired position. Once you have reached your
desired height, turn the knob clockwise to lock into position.
4