HDMI Output
Possible settings are Enabled and Disabled.
Possible settings are Channel 1, Channel 2,
Source
Channel 3,
Only available if channel direction is IP
SDI.
5.1.2
Channel Configuration
Click the configuration cog below the channel title ribbon to open the configuration
window. The user has two settings to control, Alias and Direction.
The user can assign a defining name or title to the
stream processing path. This label is only available to
Alias
the SDI2X interfaces; it will not be incorporated into the
video stream data.
Possible settings are SDI IP and IP SDI. This
Direction
setting represents the video processing path direction. It
will always be shown as (Input) (Output).
Configuring the Video/IP ports (SDI IP)
5.1.3
When the signal processing direction is SDI IP, the IP ports will be configured as
outputs.
Seamless Redundancy Enabled
When redundancy is enabled, the SDI2X will provide a primary IP output stream path on
one of the gigabit network ports, and a redundant IP output stream path on the other
gigabit network port. The output stream on both ports will contain the same content to
meet the seamless switching standard (SMPTE 2022-7). Configurable settings will be
the same for both paths/ports.
Begin by clicking on the "IP Output" configure cog icon. The IP Output Confirugation
window will have a tab for Path 1 and a tab for Path 2. There are three available settings
to configure for each path.
Page 20 (48)
SDI2X – User Manual
and Channel 4.