Cisco S195 Getting Started Manual page 8

Connect to the Appliance
The connection diagram in each topic shows the default configuration using a management computer
Note
connected to your private network. Your deployment may vary depending on your basic logical network
connectivity, ports, addressing, and configuration requirements.
Cisco S195 Appliance
Plug one end of the straight power cable into the power supply on the back panel of the appliance.
Step 1
Note
Plug the other end into an electrical outlet.
Step 2
Plug the Ethernet cables into the appropriate ports on the back panel of the appliance.
Step 3
•
•
Connect your laptop to the Management port (M1) using the Ethernet cable included in the system box.
Step 4
1
3
5
Power up the appliance by pressing the On/Off switch on the front panel of the appliance. You must
Step 5
wait 10 minutes for the system to initialize each time you power up the system. After the appliance
powers up, a solid green light on the front panel indicates that the appliance is operational.
Cisco Web Security Appliance S195, S395, S695, and S695F Getting Started Guide
8
It is optional to order a separate power cable and connect to the second power supply at the back
panel of the appliance for redundancy.
The proxy ports are labeled P1 and P2.
P1 only enabled: When only P1 is enabled, connect it to the network for both incoming and
–
outgoing traffic.
P1 and P2 enabled: When both P1 and P2 are enabled, you must connect P1 to the internal
–
network and P2 to the internet.
The traffic monitor ports are labeled T1 and T2.
Simplex tap: Ports T1 and T2; one cable for all packets destined for the internet (T1) and one
–
cable for all packets coming from the internet (T2).
Duplex tap: Port T1; one cable for all incoming and outgoing traffic.
–
Management port (M1) - (192.168.42.42)
Traffic monitor port 1 (T1)
Internet
2 Management computer (192.68.42.43)
4 WAN modem