Sony LF-X1, LF-X5 Operating Instructions Manual page 32

Auto Program (for the
External TV Tuner)
To connect a device such as a set-top box (STB)
using an antenna cable, proceed as follows.
Before making the following settings, connect the
set-top box to the base station. Also set up and
connect the IR Blaster.
For more on how to connect to devices,
see page 21. For more on how to set up and
connect the IR Blaster, see page 33.
1
Open the [Settings] window and select [TV/
Video].
The [TV/Video] window appears.
2
Select [Channel Settings].
The [Channel Settings] window appears.
3
Select [OFF] under [CABLE], turn on the
set-top box, then select [Auto Program].
Note
If the set-top box is turned off, channels received
by the set-top box cannot be preset automatically.
Make sure the set-top box is turned on.
4
When channel scanning ends successfully,
the message "Automatic channel scan has
finished." appears.
5
Confirm the message, and then select [OK].
6
Select [Back].
The [TV/Video] window reappears.
7
Select [Settings], then select [Exit].
A TV program appears.
Make sure the programs that appear are from
the STB and not the internal tuner. Then
proceed with the remote control settings.
32
Note
If programs from the STB do not appear at this
point, touch the screen and use the on-screen
remote to select channel 3 or 4, whichever
displays the STB programs.
8
Open the [Settings] window and select [TV/
Video].
The [TV/Video] window appears.
9
Select [Remote].
The [Remote] window appears.
10
Select [TV].
On the [Remote Settings] window, you can
configure the on-screen remote control.
The [TV] window appears.
11
Select [External TV tuner], and select the
make and type of the connected device, then
press [Power].
When the device is configured correctly, you
can turn it on and off by selecting [Power].
Use the sub-screen to confirm that the power
turns on and off.
If selecting [Power] several times does not
turn on and off the connected devices, make
sure the make and type you have selected are
correct.
Notes
• Even if the power turns on and off correctly
with [Power], other buttons may not be
enabled. If this happens, select [Video 1] or
[Video 2] from the Index. With the on-screen
remote that appears when you touch the screen,
confirm that the buttons are enabled by
pressing them.