Operations Of The Scanner; Power On/Off Scanner; Charge Scanner; Scan - Mindeo CR40 Series User Manual

3

Operations of the scanner

Note:
1. Please establish a Bluetooth in the range of the network before the first time of scanning barcodes.
2. The scanner can perform a barcode scan operation even though no Bluetooth network is available.
However, the scanner may react in a way that differs from what is described here if no Bluetooth is
working.

3-1 Power on/off scanner

Power on scanner: Turn the Power switch on.
Power off scanner: Turn the Power switch off.

3-2 Charge scanner

1. Please charge the scanner before the first time of use. There are two methods of charging battery
as demonstrated in Figure 3-1. The charging indicator (red LED) on the scanner is turned on when
the charging is in process. When the charging process completes, the red LED is turned off.
2. Charging time: 1.5 hours for fully charged.
Method I

3-3 Scan

3-3-1 Scan barcode

Steps:
Step 1: The scanner is powered on.
Step 2: Wear the scanner on one finger, move the scanner close to the barcode and press the trigger
button.LED lights green and flash one time when the scan is successful.

3-3-2 Scan Mode

Good-read off - The trigger button must be pressed once to activate scanning. The light source of
scanner stops scanning when there is a successful reading or no code is decoded after the Stand-by
duration elapsed.
Momentary - The trigger button acts as a switch. Press button to activate scanning and release button to
Figure 3-1 Diagram of charging battery
Method II
7