Troubleshooting - Panasonic KX-TGD510 Operating Instructions Manual

Useful Information

Troubleshooting

If you still have difficulties after following the instructions in this section, disconnect the base unit's
AC adaptor, then reconnect the base unit's AC adaptor. Remove the batteries from the handset,
and then insert them into the handset again.
General use
Problem
The handset does not turn on
even after installing charged
batteries.
The unit does not work.
I cannot hear a dial tone.
Time on the unit has shifted.
Battery recharge
Problem
I fully charged the batteries, but
– still flashes,
– is displayed, or
– the operating time seems to
be shorter.
Making/answering calls, intercom
Problem
is displayed.
For assistance, please visit http://shop.panasonic.com/support
36
TGD51x_OI(en)_1129_ver031.pdf 36
Cause/solution
R Place the handset on the base unit or charger to turn on
the handset.
R Make sure the batteries are installed correctly (page 9).
R Fully charge the batteries (page 10).
R Check the connections (page 9).
R Unplug the base unit's AC adaptor to reset the unit.
Reconnect the adaptor and try again.
R The handset has not been registered to the base unit.
Register the handset (page 25).
R The base unit's AC adaptor or telephone line cord is not
connected. Check the connections.
R Incorrect time information from incoming Caller ID
changes the time. Set the time adjustment to "Manual"
(off) (page 22).
Cause/solution
R Clean the battery ends (
with a dry cloth and charge again.
R It is time to replace the batteries (page 9).
Cause/solution
R The handset is too far from the base unit. Move closer.
R The base unit's AC adaptor is not properly connected.
Reconnect AC adaptor to the base unit.
R The handset is not registered to the base unit. Register it
(page 25).
, ) and the charge contacts
2016/11/29 10:57:38