Care And Maintenance - Stanley SLP 2050 Assembly, Care And Use Instructions

2050 psi electric pressure washer
Table of Contents

Advertisement

CARE AND MAINTENANCE

Detergents
• Use detergents designed for power washers.
Hardware stores or home centers also have power
washer detergents for different cleaning projects. The
cleaning solution should be the consistency of water
in order to prevent clogging your detergent bottle
and nozzle.
• This system applies detergent under low pressure.
The cleaning power of the detergents is enhanced
when applied with low pressure and enough time is
given to break down dirt and grime. The combination
of low pressure and chemical action is very effective
and can be better than scrubbing if applied properly.
Always spray detergent on a dry surface. Do not
pre-soak area. Wetting the surface first dilutes
the detergent and reduces its cleaning ability. Do
not allow detergent to dry on surface. On vertical
surfaces being cleaned, apply detergent to lower
surfaces and work your way up to prevent detergent
from causing streaks in the dirt and grime. Rinse
detergent by pressure washing from bottom up for
same reason.
• If a stain is particularly tough, it may be necessary
to reapply the detergent and use a bristled brush to
scrub the stain. Subsequent power washing after
brushing should successfully complete your cleaning
job.
Cleaning Garden Hose Adapter
• The screens inside the adapter should be cleaned
periodically. Rinse with clean water, and then place
back in the adapter.
14
93919_16ANR024_Stanley 2-in1_ENG-FR-SP_11_17.indd 14
Cleaning Nozzles
• A clogged or partially clogged nozzle can cause
significant reduction of water pressure coming out
of the nozzle and/or cause the unit to pulsate while
spraying.
• Turn off the unit.
• Turn off the water supply to the unit.
• Relieve any pressure trapped in the hose by squeezing
the trigger 2 - 3 times, then lock the spray gun by
turning the dial to lock ("3" and "9" position).
• Using the nozzle tip cleaner provided (or an unfolded
paper clip), insert the wire into the nozzle hole and
move back and forth until debris is dislodged.
• Back flush water through the nozzles using garden
hose and highest pressure available (either standard
water nozzle or use your thumb over the nozzle to
create water pressure for back flush).
16/12/23 下午1:06

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents