Page 2
ENGLISH FIG. A f For house hold use only Note: The diagrams are for reference, the product may change in appearance or specifications without notice.
Page 3
ENGLISH FIG. B Ø13 S/N. Fabricado na China...
Page 5
ENGLISH FIG. E FIG. F 1 ÷ 25 m 25 ÷ 50 m Volt 220-240 V~ 50 Hz 3 x 1,5 mm 3 x 2,5 mm Note: The diagrams are for reference, the product may change in appearance or specifications without notice.
USING THE MACHINE head nozzle. DO NOT RETURN THIS PRODUCT TO THE STORE, m. Accident hazard. Do not leave the appliance first contact your local STANLEY office or nearest authorized unattended. service center. n. Short circuit hazard. Do not move the appliance by pulling on the electrical cable.
Page 7
Warning! To ensure machine safety, use only original STANLEY Service Center or an equally qualified spare parts from the manufacturer or approved by the person in order to avoid damage or injury. If the manufacturer.
ENGLISH 6. Nozzle person, but not authorized by STANLEY, the warranty will not 7. Adapter be valid.. 8. Water filter 9. Detergent kit LABELS ON TOOL 10.Screws The following symbols are shown on the tool along with the 11.Electric cable with plug date code: 12.Wheels...
Page 9
ENGLISH greater its cross-section should be. will damage it. Do not cover the ventilation grilles when the appliance is in use. Water supply connection TSS Models - In TSS models with automatic delivery flow Caution! Only clean or filtered water should be used for cut-o system: intake.
SERVICE INFORMATION Inspect the inlet filter (8) and detergent filter (if fitted) before STANLEY offers a full network of company-owned and authorized each use, and clean in accordance with the instructions if service locations. All STANLEY Service Centers are staffed with necessary.
ENGLISH TROUBLE SHOOTING PROBLEM POSSIBLE CAUSES SOLUTION Nozzle worn Replace nozzle Water lter fouled Clean filter (8) (Fig. E) Insufficient water supply Turn on water supply tap fully Air being sucked into system Check tightness of hose fittings Switch off the appliance and keep depressing Pump does not reach working pressure and releasing the gun trigger until the water Air in pump...
Page 13
ENGLISH Adjustable nozzle on high pressure setting “ ” (Fig.C) set nozzle setting Detergent too dense Dilute with water No detergent sucked in High pressure hose extension being used Fit original hose Flush with clean water and eliminate any Deposits or restriction in detergent circuit restrictions.