Satellite Receiver - Sony KV-27HS420 Instructions: TV stand (primary manual) Operating Instructions Manual

Satellite Receiver

Using
S VIDEO jacks?
See page 15.
TV
Notes on Using This Connection
To Do This ...
Watch the satellite receiver
Set up the TV remote control to operate the

satellite receiver

Activate the TV remote control to operate
the satellite receiver
Control satellite receiver functions with the
TV remote control
Label video inputs to easily identify
equipment connected to the TV
To connect a satellite receiver
1
Connect the satellite antenna cable to the satellite receiver's
satellite input jack.
2
Use an A/V cable to connect the satellite receiver's A/V output
jacks to the TV's A/V input jacks.
3
Connect a CATV cable from your cable or antenna to the satellite
receiver's VHF/UHF input jack.
4
Use a coaxial cable to connect the satellite receiver's VHF/UHF
output jack to the TV's VHF/UHF input jack.
5
Run the satellite receiver's setup program (see the satellite
receiver's manual for details).
Coaxial
cable
A/V cable
Do This ...
Press TV/VIDEO
(VIDEO 1 in the illustration).
If you have a non-Sony satellite receiver, you must program
the remote control. See "Programming the Remote Control"
on pages 37-38.
Press SAT/CABLE
See "Operating a Satellite Receiver" on page 43.
See the instructions for setting up Video Labels on pages 58-
59.
CATV cable
Cables are often
color-coded to connectors.
Connect red to red,
white to white, etc.
Satellite receiver
repeatedly to select the satellite receiver input
FUNCTION.
Satellite antenna
cable
21