Setting Up The Channel List; Using Initial Setup - Sony WEGA KLV-S20G10 Operating Instructions Manual

Connecfing_e TV
Setting Up the Channel List
After you finish connecting your TV, you need to run Initial Setup, which
automatically sets up available channels. The Initial Setup screen appears
when you turn on your TV for the first time after hooking it up. If you do not
want to set up the channels at this time, you can do it later by selecting the
Auto
Program
option in the Channel lnenu (see page 45).
L_;_The factory default setting for channel selection is Cable On. For
antenna connections, run the Auto Program again after selecting
Cable Off from the menu.
c0
Using Initial Setup To run Initial Setup the first time you turn on your TV
1
Press POWER to turn on the TV.
The Initial Setup screen appears.
Press 4"or I!,on tile remote control to select the on-screen display
language. Then press @.
The message "First please connect cable/antenna" appears.
SJ By default, Auto Program is set to scan cable TV channels.
3
Press CH + to start Auto Program.
Auto Program automatically creates a list of receivable channels. When
finished, the lowest numbered channel is displayed. When all the receivable
channels are stored, the Show/Hide Channels menu appears.
To scan available VHF/UHF antenna channels instead of the cable TV
channels
1
Press MENU, then go to Channel menu.
2 Set Cable to Off.
3 Start Auto Program by pressing -_=2_,'-).
To perform Auto Program again, follow the above instructions.
Depending on your signal source, be sure to set Cable to On or Off
accordingly (see page 45).
_-Z_-J The Initial Setup menu wi!! appear each time the TV is turned on
until you complete the scanning for the available channels.
31