Upc-A - Honeywell HF800 Series Reference Manual

Redundant times: output the decode result only when got identical barcodes
information for specific times.
Minimum Length: output the decode result when the symbology length equal or
larger than the minimum length.
Maximum Length: output the decode result when the symbology length equal or
shorter than the maximum length.
Append Mode: This function allows the HF800 to append the data from several
Code 93 bar codes together before transmitting them to the host computer. When
this function is enabled, the HF800 stores those Code 93 bar codes that start with a
space (excluding the start and stop symbols), and does not immediately transmit the
data. The HF800 stores the data in the order in which the bar codes are read,
deleting the first space from each. The HF800 transmits the appended data when it
reads a Code 93 bar code that starts with a character other than a space.

UPC-A

Click the "UPC-A" in the left list then all its related parameters will be shown on the
right.
Redundant times: output the decode result only when got identical barcodes
information for specific times.
Convert UPC-A to EAN13: When UPC-A Converted to EAN-13 is selected, UPC-A
bar codes are converted to 13 digit EAN-13 codes by adding a zero to the front.
When Do not Convert UPC-A is selected, UPC-A codes are read as UPC-A.
Check Digit Transmit: This selection allows you to specify whether the check digit
should be transmitted at the end of the scanned data or not.
Number System Digit Transmit: The numeric system digit of a U.P.C. symbol is
normally transmitted at the beginning of the scanned data, but can be programmed
so it is not transmitted (Off).
2/5 Digit Addenda: This selection adds 2 or 5 digits to the end of all scanned UPC-A
data.
55