PiXORD PS760D Quick Installation Manual

PS760D Quick Installation Guide

1. Hardware Connection

Physical Connection
1. Be sure that your PC or laptop has connected to your local Ethernet network(HUB or Switch).
2. Be sure that IP Camera has connected to your local networking via the LAN port (RJ45) on the extension cable.
(For PoE model, user can use PoE Switch as power supply)
3. Plug the jack of power adaptor into power jack on the extension cable.
4. Ensure the power adaptor specification matches the power system (110V or 220V) and plug the adaptor into the
outlet. (This step is optional if used PoE switch for PoE model)
5. Use CAM FINDER software in CD to allocate your camera in networking, and launch browser to start connecting
with PC.
Pins Definition
PS760D provides extra connections with outside devices. User can apply the integrated functional cable for GPIO
and External IR Board.
Please refer to the following table of pins definition respectively:
<English>
1
Dual Lens Panoramic
Dome Network Camera

Bracket Installation

NO. A-1 B-1 A-2
Quantity 3 4 / 4 3
Screws
Wall Mount & Ceiling Mount
Align and insert the 4 screw
pins to the 4 anchor points of
Install the Bracket(B-2) by
Step 2
Step 1
the bracket correspondingly.
applying the Screw(B-1)*4pcs.
Rotate clockwise to fix the camera.
Figure I Figure II
In-Ceiling Mount
Take Screw(A-1)*3pcs. Insert each
Loose the 4 screws of cover and
screw through the pan and then
Step 1 Step 2
remove the cover.
the Bracket(A-2).
Figure II
Figure I
B-2
1
Concurrently squeeze the
Bracket(A-2)*3pcs into the ceiling
Step 3 mezzanine. Tighten the 3 screws
to securely fasten the camera.
Finally, install the camera cover.
Figure III
53IT-00000137
2 V1.0