Workzone Titanium+ BL20AL Instruction Manual page 13

Drill safety warnings
1 ) Safety instructions for all operations
a) Hold the power tool by insulated gripping surfaces, when
performing an operation where the cutting accessory
or fasteners may contact hidden wiring or its own cord.
Cutting accessory or fasteners contacting a "live" wire may make
exposed metal parts of the power tool "live" and could give the
operator an electric shock.
2) Safety instructions when using long drill bits
a) Never operate at higher speed than the maximum speed
rating of the drill bit. At higher speeds, the bit is likely to
bend if allowed to rotate freely without contacting the
workpiece, resulting in personal injury.
b) Always start drilling at low speed and with the bit tip
in contact with the workpiece. At higher speeds, the
bit is likely to bend if allowed to rotate freely without
contacting the workpiece, resulting in personal injury.
c) Apply pressure only in direct line with the bit and do not
apply excessive pressure. Bits can bend causing breakage
or loss of control, resulting in personal injury.
Screwdriver and impact wrench safety warning
1. Hold power tool by insulated gripping surfaces, when
performing an operation where the fastener may contact
hidden wiring. Fasteners contacting a "live" wire may
make exposed metal parts of the power tool "live" and
could give the operator an electric shock
AFTER SALES SUPPORT
1300 889 028 (toll free)
13
e-mail:
info.aldi@positecgroup.com
MODEL No.:
BL20AL • 8213 • 06/2019
13