Table of Contents
Advertisement
Warnings
Warnings
The following warnings are for the setup, use, grounding, maintenance, and repair of this equipment. The
exclamation point symbol alerts you to a general warning and the hazard symbols refer to procedure-specific risks.
When these symbols appear in the body of this manual or on warning labels, refer back to these Warnings.
Product-specific hazard symbols and warnings not covered in this section may appear throughout the body of this
manual where applicable.
SEVERE ELECTRIC SHOCK HAZARD
This equipment can be powered by more than 240V. Contact with this voltage will cause death or
serious injury.
•
Turn off and disconnect power at main switch before disconnecting any cables and before servicing
equipment.
•
This equipment must be grounded. Connect only to grounded power source.
•
All electrical wiring must be done by a qualified electrician and comply with all local codes and
regulations.
FIRE AND EXPLOSION HAZARD
Flammable fumes, such as solvent and paint fumes, in work area can ignite or explode. Paint or
solvent flowing through the equipment can cause static sparking. To help prevent fire and explosion:
•
Use equipment only in well ventilated area.
•
Eliminate all ignition sources; such as pilot lights, cigarettes, portable electric lamps, and plastic
drop cloths (potential static sparking).
•
Ground all equipment in the work area. See Grounding instructions.
•
Never spray or flush solvent at high pressure.
•
Keep work area free of debris, including solvent, rags and gasoline.
•
Do not plug or unplug power cords, or turn power or light switches on or off when flammable fumes
are present.
•
Use only grounded hoses.
•
Hold gun firmly to side of grounded pail when triggering into pail. Do not use pail liners unless they
are anti-static or conductive.
•
Stop operation immediately if static sparking occurs or you feel a shock. Do not use equipment
until you identify and correct the problem.
•
Keep a working fire extinguisher in the work area.
Static charge may build up on plastic parts during cleaning and could discharge and ignite flammable
vapors. To help prevent fire and explosion:
•
Clean plastic parts only in well ventilated area.
•
Do not clean with a dry cloth.
•
Do not operate electrostatic guns in equipment work area.
SPECIAL CONDITIONS FOR SAFE USE
•
If using the Viscon HP Heaters see manuals for special conditions for safe use.
•
If using the PressureTrak, see the manual for special conditions for safe use.
4
DANGER
WARNING
3A0420ZAF
Advertisement
Table of Contents
