Installation (For Engineers Only); Mounting The Controller On A Wall - Buderus Logamatic SC40 Installation And Servicing Instructions

Installation (for engineers only)

4
4 Installation (for engineers only)
4.1

Mounting the controller on a wall

The controller is attached to the wall by three screws.
Caution: Risk of injury and damage to the casing if incorrectly mounted.
V Do not use the rear panel of the casing as a drilling template.
V Drill the upper mounting hole (
Slacken the screw at the bottom of the controller and remove the cover. Hang the controller on
the wall by means of the slot in the rear panel. Mark out the lower mounting holes (
item 2), drill the holes and insert wall plugs. Straighten the controller and screw firmly in place
through the lower mounting holes, left and right.
5 mm
Fig. 3 Mounting the controller on a wall
1 Top fixing hole
2 Bottom fixing holes
8
Fig. 3, item 1). Drive in a screw leaving the head proud by 5 mm.
1
2
Logamatic SC40 - Technical specifications are subject to change without prior notice.
Fig. 3,
7747006072-01.1 SD