Sony Bravia KDL-W40A12U Operating Instructions Manual page 31

Option Description
Programme Presets programme channels manually.
1
Channel
2
3
4
5
6
7
8
Repeat the procedure above to preset other channels manually.
Label Assigns a name of your choice, up to five letters or numbers, to the
selected channel. This name will be displayed briefly on the screen
when the channel is selected.
1
2
3
AFT Fine-tunes the selected programme number manually if you feel
that a slight tuning adjustment will improve the picture quality.
(Normally, fine tuning is performed automatically.)
1
2
3
To restore automatic fine tuning, select "On" in step 1.
Audio Filter
Improves the sound for individual channels in the case of distortion
in mono broadcasts. Sometimes a non-standard broadcast signal
can cause sound distortion or intermittent sound muting when
watching mono programmes.
1
2
3
Note
You cannot receive stereo or dual sound when "Low" or "High" is
selected.
Press M/m to select "Programme", then press OK.
Press M/m to select the programme number you want
to manually tune (if tuning a VCR, select channel 0),
then press <.
Press M/m to select "Channel", then press OK.
Press ,.
Tune the channels as follows:
If you do not know the channel number (frequency)
Press M/m to search for the next available channel. When a
channel has been found, the search will stop. To continue
searching, press M/m.
If you know the channel number (frequency)
Press the number buttons to enter the channel number of the
broadcast you want or your VCR channel number.
Press OK.
Press m to select "Confirm", then press OK.
Press m to select "OK", then press OK.
Follow steps 3 to 5 of "Programme Labels" (page 30).
Press m to select "Confirm", then press OK.
Press m to select "OK", then press OK.
Press M/m to adjust the fine tuning over a range of -15
to +15, then press OK.
Press m to select "Confirm", then press OK.
Press m to select "OK", then press OK.
Press M/m to select "Low" or "High", then press OK.
If you do not experience any sound distortion, we recommend
that you leave this option set to the factory setting "Off".
Press m to select "Confirm", then press OK.
Press m to select "OK", then press OK.
Continued
31