Download Print this page

Plasmon Raidtec FS3102 Quick Start Manual page 4

Advertisement

Default IP Settings
By default, the FS3102 is configured to use DHCP for assigning IP addresses. If DHCP is
not enabled and no IP address has been assigned previously, the Raidtec FS3102 system
will use the Default IP Address shown on the cover of this document. This Default IP
Address is intended for temporary use only. If DHCP is not being used, we strongly
recommend that you set the IP address to a permanent address on the local subnet.
Figure 4 – Open Connection
IP Connection Screen
If you fail to connect to your chosen system, you
will be asked if you want to go to the IP Connection
Screen. Here you may reconfigure the IP settings
for the system. When you do this and click on
Save Configuration you will return to the System
Search Screen where you should see your system
at the bottom of the list.
Default RAID Configuration
The Raidtec FS3102 system comes pre-configured with one disk reserved as a global spare
and the remaining disks at RAID level 5 with the File Server profile. This configuration has
one Logical Volume of 10GB, which needs to be mapped to the HBA of the host computer.
The capacity of this Logical Volume may be expanded, as required. All caching options are
enabled (caching options can be changed without deleting the RAID). If a different RAID
configuration is required, this RAID may be deleted.
Note: It is highly recommended that one disk be reserved as a global spare to allow an
automatic rebuild of the RAID in the event of a disk failure.
Raidtec FS3102 Quick Start Guide
Raidtec FS3102 Quick Start Guide
Raidtec FS3102 Quick Start Guide
Raidtec FS3102 Quick Start Guide
Open Connection Screen
After selecting a system from the Search screen or entering
the IP address of the system manually, you must open a
connection to the system. For your first connection, use
"admin" for both Username and Password. When this default
password is entered, the system will go to the Setup Wizard
screen
where
you
administration settings.
4
can
set
up
your
Figure 5 – IP Connection Screen
network
and

Advertisement

loading