Physical Characteristics; Circular Bubble Level; Levelers - Siemens Hematek Operating Manual

Physical Characteristics

Figure 1-2. Circular Bubble Level and Leveling Feet, shows the physical characteristics of
the Hematek Slide Stainer, including the circular bubble level and the leveling feet.
Figure 1-2. Circular Bubble Level and Leveling Feet
1

Circular Bubble Level

2 Leveling Feet

Circular Bubble Level

CAUTION
Do not move the circular bubble level from its location directly behind the operating lever.
Proper leveling is essential for optimal mixing of the stain and buffer.
The circular bubble level is a water bubble gauge with an inscribed circle that can be
observed through the clear plastic lid of the instrument. The level is located on the
instrument panel to the left of the reagent pumps, directly behind the operating lever. It is
used to ensure the Slide Stainer is in a level position.

Levelers

The feet under the front corners of the instrument act as levelers and may be adjusted to
raise or lower the instrument to a level position. Observe the circular bubble level to verify
that the feet have been properly adjusted and the instrument is level.
Section 1: Introduction, Page 1—5