Table of Contents
Advertisement
Operation (Continued)
Changing Fahrenheit to Celsius
The temperature displays in degrees Fahrenheit as a factory set default. Follow these steps to change to
degrees Celsius:
Step 1: Remove the cover and the batteries.
Step 2: Move the F/C jumper to the desired position, F or C using the center pin as a common.
Step 3: Reinstall the batteries and the cover.
Your LCD readout changes accordingly.
Starting the Thermostat
Step 1: Move the Fan switch into the Auto position.
• In Auto, indoor fan runs only during a heating or cooling cycle
• In ON, indoor fan runs continuously
Step 2: Move the Mode switch to either Cool or Heat position, depending on
the season. The thermostat will now operate and maintain the room
temperature at the desired setpoint.
Note: When the thermostat operates the system, there is built-in
compressor protection. After the compressor turns off, the
system will not turn it back on for about five minutes. This
protects the compressor.
Fan
Auto
On
Mode
Cool Off Heat
Advertisement
Table of Contents
