Casio 5594 Operation Manual page 32

Hand Alignment
Adjustment
Strong magnetism or impact can cause the
time indicated by the analog hands to become
different from the time on the digital display. If
this happens, adjust hand alignment.
Adjusting Hand Alignment
1.
Enter the Timekeeping Mode.
Navigating Between Modes
l
2.
Hold down (D) for at least five seconds.
Release the button when [00] starts to
flash.
This enables adjustment of second hand
alignment.
After 3.5 seconds After five seconds
Second hand
3.
If the second hand is not at 12 o'clock, use
(A) and (C) to align it.
4.
Press (E).
This enables adjustment of the hour and
minute hands.
Hour hand Minute hand
5.
If the hour hand and minute hand are not
at 12 o'clock, use (A) and (C) to align them.
6.
Press (D) to exit the setting screen.
Operation Guide 5594
Other Settings
This section explains other watch settings you
can configure.
Enabling the Button
Operation Tone
Use the procedure below to enable or disable
the tone that sounds when you press a button.
1.
Enter the Timekeeping Mode.
Navigating Between Modes
l
2.
Hold down (D) for at least two seconds.
Release the button when the name of the
currently selected Home City appears on
the display.
3.
Press (E) twice.
This causes [KEY♪] or [MUTE] to flash on
the display.
4.
Use (A) to select [KEY♪] or [MUTE].
[KEY♪]: Operation tone enabled.
[MUTE]: Operation tone muted.
5.
Press (D) twice to exit the setting screen.
Note
Note that alarm and timer tones will still
●
sound even while the operation tone is
muted.
Reflecting Altitude
Differential in Activity
Measurements
You can use the procedure below to specify
whether or not you want to reflect altitude
differential in physical exertion
measurements.
Note
Reflecting altitude differential
●
information in activity measurements
makes it possible to obtain more
accurate activity calculations.
G-SHOCK Connected is used to
●
specify your height and weight, and to
calculate physical exertion.
This information is not displayed on the
Home City
watch.
1.
Enter the Timekeeping Mode.
Navigating Between Modes
l
2.
Hold down (D) for at least two seconds.
Release the button when the name of the
currently selected Home City appears on
the display.
3.
Press (E) six times.
This will display [SLOPE], followed by a
flashing [ON] or [OFF].
4.
Use (A) to select [ON] or [OFF].
[ON]: Altitude differential reflected in
physical exertion measurements.
[OFF]: Altitude differential not reflected in
physical exertion measurements.
5.
Press (D) twice to exit the setting screen.
Home City
32