Model Nomenclature - Bosch LM Series Installation, Operation And Maintenance Manual

LM Series Heat Pump

MODEL NOMENCLATURE

LM
Size
024
036
048
060
070
Voltage
1 208-230/60/1
2 277/60/1
3 208-230/60/3
4 460/60/3
Cabinet Configuration
HZ - Horizontal
VT - Vertical
Coax Options
C - Copper
N - Cupro-Nickel
Installation and servicing of this equipment
can be hazardous due to system pressure
and electrical components. Only trained
and qualified personnel should install,
repair, or service the equipment.
Before performing service or maintenance
operations on the system, turn off main
power to the unit. Electrical shock could
cause personal injury or death.
When working on equipment, always
observe precautions described in the
literature, tags, and labels attached to the
unit. Follow all safety codes. Wear safety
glasses and work gloves. Use a quenching
cloth for brazing, and place a fire
extinguisher close to the work area.
Revised 09-13
LM 024 - 1 VT C - F L T - T A
Revision Level
A - Current
Fan/Motor Options
A - Constant Airflow ECM
T - Constant Torque ECM
Discharge Air Configuration
T - Top (VT only)
S - Straight (HZ only)
E - End (HZ only)
Return Air Configuration
L - Left
R - Right
Water Connections
F - Front
All refrigerant discharged from this unit
must be recovered WITHOUT EXCEPTION.
Technicians must follow industry accepted
guidelines and all local, state, and federal
statutes for the recovery and disposal of
refrigerants. If a compressor is removed
from this unit, refrigerant circuit oil will
remain in the compressor. To avoid leakage
of compressor oil, refrigerant lines of the
compressor must be sealed after it is
removed.
To avoid equipment damage, DO NOT use
these units as a source of heating or cooling
during the construction process. Doing so
may affect the unit's warranty. The
mechanical components and filters will
quickly become clogged with construction
dirt and debris, which may cause system
damage.
| 3
8 733 905 315 (2013/9)