E.T. Systems UMPETHA Installer's Instructions page 9

30 to 50mm between the proudest part of the
gate and the edge of the base plate
Top view
Install the base plate on the protected side of the driveway wherever possible. (opposite side of the guide post to the driveway) The base
plate must be installed 30 to 50mm away from the proudest part of the gate. The wheel bolt is the proudest part of the gate here. If in doubt
rather install the base plate further away and use spacers between the gate fascia and the rack when installing the rack.
Base plate
Coach screws through
angle mounting tabs
10mm masonry drill bit.
Conduiting
Pre-cast concrete
plinth
Base plate
Fold out tabs
Roofing bolts pre-
assembled onto base
plate
Conduiting
Freshly cast concrete
plinth
UMPETHA 082009/072010.014
Motor positioning to gate.
Hot tip: Cast the track plinth at the same time as the motor plinth
300mm
Sectional side view of a baseplate mounted on a previously cast plinth
Sectional side view of a baseplate set in a freshly cast plinth
Guide post
9