E.T. Systems UMPETHA Installer's Instructions page 28

The courtesy light output will activ ate on any opening trigger (BT or Pedestrian). The light output will remain
Beeps Gate status
5 x Rapid
Full closed
beeps
Continuous Gate
rapid beeps anywhere
Gate
5 x Rapid
anywhere
beeps
but closed
Opens 1m
1 x 5sec beep
and remains
(long beep)
there.
2 x Rapid Gate
beeps anywhere
3 x 1sec. Beeps Gate closed
Gate
2 x 2sec. Beeps
stopped
1 x 5sec beep Gate
(long beep) stopped
20 x 1sec. Gate
Beeps. stopped
Slow flash
Rapid Flash
UMPETHA 082009/072010.014
Available in all modes.
on until three minutes after the gate has re-closed.
Program
Action
Jumper
Momentary
Off BT or Ped
input
On None
Momentary
Off BT or Ped
input
Momentary
Off BT or Ped
input
Momentary
Off or On BT or Ped
input
Momentary
Off
Ped
Momentary
Off
BT
Any input
Off
triggered
First BT input
after a reset
or Set
Off or On
button in
runtime set
up
Status LED overview
Off
Gate is running or w aiting for auto-close time to time out
On
Gate is obstructed or has exceeded max run time.
Courtesy light out
Response
Condition
Motor
Holiday lock-
None
out active
Holiday lock-
None
out active
Auto-close
None override/party
mode active
None limit failure
Battery flat or
Attempts to run
Pedestrian
Gate opens
function
partially
activated
Household
Gate runs
mains failure
Multiple
None collision lock-
No motor
movement
detected or
beam input is
None
activated
before the
closed limit is
Gate closed
28
Gate is open
Solution
Toggle off
Toggle off
Toggle off
check magnet on
gate and limit switch
Allow recharge and
check for Aux devices
overload. If problem
faulty persists after ±8 hours
charging, replace
battery
Restore power supply
Check gate closing
resistance
out
Check beam circuit or
setting. Check gate
resistance. Check
motor and battery
wiring/looms.
seen.
Table ref:
pg 26
pg 26
pg 27
pg 20
pg 27
pg 20
pg 19, 20
&14