Sundance Spas 880 Series Owner's Manual page 69

Pump Priming Instructions:
This method must be used for the jets pumps because these pumps
are not connected to the main filter system in any way.
1. Turn off the power to the spa.
2. Remove the handle from the massage selector supplied by the pump
you are priming.
3. Loosen the massage selector's cap slightly (counterclockwise), lis-
tening for the air to seep out.
4. Tighten the cap finger tight, replace the handle, and turn the spa's
power back on.
CAUTION: If freezing conditions exist and pump is not opera-
tional, take measures to protect the system from freeze damage.
See Section titled "Winterizing", page 57.
PROBLEM
Poor jet acton
(See figures G-M,
pages 22-28)
Water is too hot
No heat
PROCEDURE
1. Make certain the jets pump is turned on.
2. Check position of massage selectors.
3. Open air control for selected jet system.
4. Check for adequate water level.
5. Check for dirty filter (pages 53-54).
1. Reduce thermostat setting (page 16).
2. Switch hot tub to "Economy" mode to turn
heater on only during programmed filter
cycles (page 48).
1. Check thermostat setting.
2. Keep the cover in place while heating.
3. If "heater on" indicator is lit (page 21) but
no temperature rise is experienced after
a reasonable period of time, contact your
Sundance Spas dealer or qualified service
technician.
Page 63