Table of Contents
Advertisement
RN333300 MUK Rev3.qxp_IB 05/06/2018 09:37 Page 7
Using the Steam Generator
1a) Removing and filling the water tank
Remove the detachable water tank
water tank removal tabs (19), open the filling cap
(12), and fill with water to the max fill line. Replace
the water tank.
IN HARD WATER AREAS, WE RECOMMEND A
MIX OF 50% TAP WATER AND 50% DISTILLED,
DEIONISED OR DEMINERALISED WATER.
Never use battery topping up fluid or water
containing any substances like starch, sugar,
fragrant additives or defrosted water from a
refrigerator.
NOTE: Please see point 2 of 'Exclusions' on page 12.
Re-filling during use
If the water level is too low, the low water indicator
will illuminate and the unit will not produce steam.
If this happens, refill the detachable water tank
(13)
with water.
2) Default IntelliTemp Setting
Plug the appliance into a mains outlet to switch
the product on. A beep will be heard and the
IntelliTemp logo
(31)
panel (8). The default temperature is the
IntelliTemp setting, this allows the appliance to
iron all ironable fabrics without the temperature
needing to be adjusted. However, do not iron
any fabric with this symbol
setting indicator
(31)
remain constant when the IntelliTemp setting is
reached.
(13)
using the
will illuminate on the control
. The Intellitemp
will stop flashing and
1b) Filling the water tank in situ
Alternatively, the water tank may be filled
without removing it from the base unit (17).
Simply open the filling cap (12), and fill the
water tank with water to the max fill line.
3) Temperature Selection
If a different temperature than IntelliTemp
setting is required to suit the garment (see
'Temperature guide' on page 6), you may adjust
the temperature as follows: press the select
button
(20)
repeatedly until the required
temperature setting indicator
displayed. Pressing the select button cycles the
options as shown in the next step.
(22/23/24/25)
is
7
Hide quick links:
Advertisement
Table of Contents
