Table of Contents
Advertisement
RN333300 MUK Rev3.qxp_IB 05/06/2018 09:37 Page 9
Dry ironing
To use your steam generator as a dry iron only,
follow steps 2, 3, 4 and 5 of 'Using the Steam
Generator' on page 7 and 8. You do not need to
put water in the water tank (13).
Auto shut-off
If the steam trigger
the product will automatically turn off for safety
and to save energy. When this happens, the auto
shut-off indicator
To restart, press the select button
for the temperature to rise again.
NOTE: The appliance is not turned off completely
in auto shut-off mode. To switch the product off,
unplug the product from the mains outlet.
Maintenance
The product requires an antiscale cartridge to
help reduce limescale and extend its life. The
antiscale indicator
you to replace the antiscale cartridge which is
located in the base unit
(13). The antiscale indicator
after the antiscale cartridge has been replaced.
(4)
is not used for 10 minutes,
(30)
will flash.
(20)
and wait
(29)
will illuminate to prompt
(17)
behind the water tank
(29)
will go out only
Steam function
During steaming, small amounts of water may be
ejected from the soleplate (6). This is normal and
can be avoided by using the steam for short
amounts of time and only when the iron is at the
correct temperature (the temperature setting
indicator
(22/23/24/25/31)
stops flashing when ready).
Sudden jolts to the boiler unit can also cause
water droplets on the soleplate; therefore, do not
move the base unit
(17)
during ironing.
We recommend for first time ironing that you
iron over an old towel.
Vertical steam
Vertical steam is useful for removing creases
from hanging clothes, curtains, upholstery, etc.
Hold the iron
(5)
between 1cm and 2cm away
from the item and press the steam trigger
twice in quick succession for a longer boost of
steam. To turn the steam boost off, press the
steam trigger again.
WARNING: Do not use the vertical steam
feature on clothes that are being worn.
on the control panel
(4)
4
9
Hide quick links:
Advertisement
Table of Contents
