Using The Steam Generator For Steam Ironing; Dirty Water - Morphy Richards Power Steam Elite Instruction Manual

RN332000MUK Rev1.qxp_IB 11/09/2014 10:46 Page 7

Using the Steam Generator for steam ironing

When steam ironing, remove the detachable
water tank (15), lift the filling cap (9), and fill with
water to the max fill line. Replace the water tank.
IMPORTANT: Never fill the dirty water
chamber (10).
Turn the temperature dial
(see 'Temperature guide' on page 6). The
temperature indicator light
the temperature is reached. Begin ironing when
the temperature indicator light goes out. If you
turn the temperature dial down, wait until the
temperature indicator light illuminates and then
goes off again.
1
3
(5) to suit the garment
(7) illuminates until
Plug the appliance into a mains outlet, you will
hear a beep. Press the On/Off button (31), it will
beep again and the power indicator light
will illuminate and the low steam level indicator
light (27) will flash.
18
Unlock the iron from its storage position on top
of the base unit (22) by pressing and holding the
iron release button (18) (marked with a padlock
icon) - this enables you to rotate the tip of the
soleplate (6) (in a clockwise direction) out from
under the iron-to-base locking hook
the iron heel (8) away from the rear docking
hook (20).
WARNING: To avoid burning yourself if the
soleplate is still hot, never press down on the
iron-to-base locking button
iron.
During use, the iron may be rested on the iron
rest plate (19) with the soleplate tip on top of the
iron-to-base locking hook (16)
slotted on to the rear docking hook.
2
(26)
4
(16) and lift
(17) to unlock the
and the heel
7