Sawing; Planing, Sanding, Routing - Black & Decker Workmate 200 Instruction Manual

Rear
Vise Jaw
Vise
Crank
Crank
Handle
Sawing
In its lower position, the Work
Center is a sawhorse.
Holds material securely.
Sawing tubular pieces is easy
when they are held horizontally in the
specially designed "V' grooves
running along the face of the vise jaws
CAUTION: Swivel pegs are to be
used only in cases where the
workpiece DOES NOT extend
beyond the surface of the two vise
jaws. Black & Decker supplies, at
extra cost, clamps for securing larger
projects to your Workmate and "C"
clamps are available at your local
hardware store.
Vertical "V" grooves in the face of
the vise jaws permit rigid vertical
grasping of tubular objects.
NOTE: Place your foot as shown
on the footboard of the Work Center to
steady it. DO NOT USE AS A STEP,
Planing,
Sanding, Routing
Your Workmate® Work Center
permits you to do a better job when
planing, sanding, and routing because
work is held securely.
Holds material at perfect height
and position. Strength and stability to
handle large and awkward sizes and
shapes.
Power sand the most irregular
shapes. "C" clamps hold material
securely.
Spec:al tasks won't mean special
problems any more. Routing can be
easy and the results more professional.
7