Specifications; General Safety Rules - Makita VR250D Instruction Manual

ENGLISH

SPECIFICATIONS

Vibrations per minute (min
Vibrations amplitude
Vibration head (diameter x length)
Flexible shaft assembly length
• Due to our continuing programme of research and development, the specifications herein are subject to change without notice.
• Note: Specifications may differ from country to country.
Symbols
The following show the symbols used for the equipment.
Be sure that you understand their meaning before use.
･
Do not use the tool in the rain.
･
Do not clean the tool with water.
･
Only for EU countries
Do not dispose of electric equipment
together with household waste material!
In observance of European Directive
2002/96/EC on waste electric and
electronic
implementation in accordance with
national law, electric equipment that
have reached the end of their life must
be collected separately and returned to
an
recycling facility.
Intended use
The tool is intended for removing bubbles from concrete
when casting concrete.
For European countries only
Noise
The typical A-weighted noise level determined according
to 60745-1:
Sound pressure level (L
Uncertainty (K) : 3 dB(A)
The noise level under working may exceed 85 dB (A).
Wear ear protection.
Vibration
The vibration total
determined according to EN60745-1:
Work mode : operation without load
Vibration emission (a
Model
-1
)
Overall length
Net weight
Rated voltage
equipment and
environmentally compatible
) : 73 dB(A)
pA
value (tri-axial vector
2
) : 2.5 m/s or less
h
END003-1
EC-DECLARATION OF CONFORMITY
Model; VR250D
We declare under our sole responsibility that this
product is in compliance with the following standards of
standardized documents;
EN60745,
Directives, 2004/108/EC, 98/37/EC.
000230
Responsible Manufacturer:
Makita Corporation
its
3-11-8, Sumiyoshi-cho, Anjo, Aichi, JAPAN
Authorized Representative in Europe:
Makita International Europe Ltd.
Michigan Drive, Tongwell, Milton Keynes, Bucks MK15
8JD, ENGLAND
ENE055-1

GENERAL SAFETY RULES

WARNING! Read all instructions. Failure to follow all
instructions listed below may result in electric shock, fire
ENG101-1
and/or serious injury. The term "power tool" in all of the
warnings listed below refers to your mains-operated
(corded) power tool or battery-operated (cordless) power
tool.
SAVE THESE INSTRUCTIONS.
Work area safety
1. Keep work area clean and well lit. Cluttered and
dark areas invite accidents.
ENG226-1
2. Do not operate power tools in explosive
sum) atmospheres, such as in the presence of
flammable liquids, gases or dust. Power tools
create sparks which may ignite the dust or fumes.
3. Keep children and bystanders away while
2
VR250D
13,000
1.1 mm
25 mm x 221 mm
800 mm
1,031 mm
2.9 kg
D.C. 12 V
EN55014 in accordance
CE2006
Tomoyasu Kato
Director
ENH102-6
with Council
GEA002-3