Zolix Instruments SC300 Operation Manual page 13

?Z,z↓
ER↓
'x' is the value of the position, as well as y and z.
（11） Inquiring the top_speed
Command from PC to SC300:
XV↓
YV↓
ZV↓
Command from SC300 to PC:
XV,top_speed↓
YV,top_speed↓
ZV,top_speed↓
ER↓
（12） Inquiring the initial speed
Command from PC to SC300:
XF↓
YF↓
ZF↓
Command from SC300 to PC:
XF,init_speed↓
YF,init_speed↓
ZF,init_speed↓
ER↓
The 'init_speed' is the initial speed.
（13） Inquiring the acceleration
Command from PC to SC300:
XA↓
YA↓
ZA↓
Zolix Instruments Co., Ltd.
Communication Protocol and Commands Explanations
// the current position z of the stage in Z axis
//inquiring the top_speed of the stage moving in X axis.
// inquiring the top_speed of the stage moving in Y axis.
// inquiring the top_speed of the stage moving in Z axis.
//the top_speed of the stage moving in X axis.
// the top_speed of the stage moving in Y axis.
// the top_speed of the stage moving in Z axis.
// inquiring the initial speed of the stage moving in X axis.
// inquiring the initial speed of the stage moving in Y axis.
// inquiring the initial speed of the stage moving in Z axis.
// the initial speed of the stage moving in X axis.
// the initial speed of the stage moving in Y axis.
// the initial speed of the stage moving in Z axis.
// inquiring the acceleration of the stage moving in X axis.
// inquiring the acceleration of the stage moving in Y axis.
// inquiring the acceleration of the stage moving in Z axis.
http://www.zolix.com.cn E-mail:info@zolix.com.cn
11