Zolix Instruments SC300 Operation Manual page 11

（5） Setting the acceleration:
Command from PC to SC300 : AX,acc_speed↓
Command from PC to SC300 : AY,acc_speed↓
Command from PC to SC300 : AZ,acc_speed↓
Command from SC300 to PC: OK↓
The "acc_speed" is the acceleration of the stage moving.
（6） Setting the initial speed
Command: PC
Command from PC to SC300 : FX,init_speed↓
Command from PC to SC300 : FY,init_speed↓
Command from PC to SC300 : FZ,init_speed↓
Command from SC300 to PC: OK↓
The "init_speed" is the initial speed of the stage moving.
（7） Stop moving
Command from PC to SC300 : SPX↓ //stop the stage moving in the X direction
Command from PC to SC300 : SPY↓ //stop the stage moving in the Y direction
Command from PC to SC300 : SPZ↓ //stop the stage moving in the Z direction
Command from SC300 to PC: ?X,x↓// the stage position in the X direction
（8） Go back to the mechanical zero position
Command from PC to SC300 : HX↓ //Go to the zero position of X axis
Zolix Instruments Co., Ltd.
Communication Protocol and Commands Explanations
ER↓
SC300
ER↓
?Y,y↓// the stage position in the Y direction
?Z,z↓// the stage position in the Z direction
ER↓ // Error
http://www.zolix.com.cn E-mail:info@zolix.com.cn
9
// X axis
// Y axis
// Z axis
// X axis
// Y axis
// Z axis