Table of Contents
Advertisement
UNPACKING UNIT:
Your Blaze Series Grill comes pre-assembled and requires very little setup. We do however; recommend the use
of professional help during the installation of your unit as improper installation may affect your warranty. When
moving or transporting your grill, NEVER do so by lifting on the hinge of the grill. Your kamado grill comes with
the attached feet screwed down to the pallet. Remove screws and inner components before lifting. The lower air
inlet can be used for lifting as long as gloves are used. Always use 2-3 people when moving the grill. Remove
the unit from the box along with all accessories and check that no damage has occurred to the unit or any parts.
Various parts of the grill are shipped with protective packaging and supports which will need to be simply
unpackaged and set in place.
Your grill has an ash tray which goes in the very bottom of the grill. The charcoal grate gets installed above the
ash tray. There is also a middle grate which goes between the charcoal grate and the cooking grid which is
used in some cooking applications. Install this piece for the initial burn off and then as needed throughout. The
cooking grids rest at the top of the kamado body and is the final item of installation.
WARNING: Every part of the grill will be hot during and for a
period of time after use. Use caution, keep children away from
the grill, and always use gloves and protective clothing during
use. Never touch the kamado body while in use.
▪
TAKE EXTREME CAUTION WHEN OPENING THE GRILL LID AS HOT COALS CAN FLASH SHOULD
THEY RECEIVE A RUSH OF AIR. ALWAYS ENSURE BOTH THE TOP AND BOTTOM VENTS ARE
OPEN FULLY BEFORE OPENING THE GRILL LID. ALWAYS OPEN THE LID TO ROUGHLY 1-2" AND
HOLD IT THERE FOR 5-10 SECONDS TO LET OXYGEN SLOWLY ENTER THE GRILL. THEN
COMPLETELY LIFT THE LID OPEN SLOWLY. AT ALL TIMES THE USE OF LONG HEAT RESISTANT
GLOVES IS NECESSARY FOR SAFETY.
Blaze Outdoor Products Instructional Book
Page | 10
Advertisement
Table of Contents
