Hayward OmniLogic How-To Manual page 6

How To: Sync Remote with Network (cont.)
The HLWIRELESS communicates through the router and not directly with the
OmniLogic unit.
Step 5 Step 6
Once connected, tap the check mark in the The remote will automatically scan the
lower right. network for the OmniLogic.
Step 7 Step 7b
IF the scan was successful the wireless remote IF the scan fails a pop-up will appear, press the
will populate with the dashboard information check mark and retry Config>Network. If it still
seen on the MSP. fails reset the Wireless Remote (next section).
NOTE: IF the OmniLogic is connected to Wi-Fi, make sure the HLWIRELESS is connected
6
to the same network and not one with a different SSID or network name.