Recorder Settings (System 1) - Sony 4-151-079-11(1) Operating Instructions Manual

Recorder Settings
(System 1)
Standby Mode
Mode 1
When the recorder is turned
off,
– Input signals from the
– Aerial input signals are not
To watch TV, use a splitter to
divide aerial input signals
between the TV and the
recorder (page 14).
Mode 2
When the recorder is turned
off, input signals from the
LINE 1 jack are output from
the LINE 3 – TV jack and
aerial input signals are output
to the connected TV. The
standby power consumption is
higher than that of "Mode 1."
Auto Power off
On The recorder automatically
turns off when you do not
press any buttons for 6 hours
in stop mode. The display asks
for confirmation about one
minute before the recorder
turns off. If you want to keep
the recorder on, select
"Cancel," and press
Off Turns off the function.
72
LINE 1 jack are not output
from the LINE 3 – TV jack
(page 23).
output to the connected TV.
Auto Chapter
The recorder can automatically divide a
recording (title) into chapters by inserting
chapter marks. You can select chapter mark
intervals or disable this function.
Off
10 minutes
15 minutes
b
• The actual chapter mark interval may vary
depending on the amount of information
contained in the video to be recorded.
• The "Auto Chapter" function is not available
during dubbing.
EP Mode Time
Sets the maximum continuous recording
time for recording in EP mode (only for
analogue broadcasts or an external input).
6 hours
8 hours
Control for HDMI
.
On
Off
No chapter mark is
inserted.
Inserts chapter marks at
approximately 10-minute
intervals.
Inserts chapter marks at
approximately 15-minute
intervals.
Allows you to record
continuously for 6 hours.
Allows you to record
continuously for 8 hours
with lower picture
quality.
Allows you to use the
"Control for HDMI"
function (page 18).
Turns off the function.